Mechanics: how long a breaker bar might one need, part 1

Self-tutoring about real-life situations in mechanics: the tutor mentions one with a cheater bar.

I mention in my post from Nov 14, 2026 the idea of making sure, beforehand, that one will be able to unfasten bolts when one needs to.

A few days back, in such a situation, I had applied penetrating fluid, then waited about fifteen minutes. (I could have waited longer, of course.)

The caliper bolts came loose easily enough, but the carrier bolts refused to budge. I wasn’t too surprised: in my experience, carrier bolts, especially at the front of a vehicle, can be especially hard to loosen.

Nonetheless, the carrier bolts would have to removed when I would tackle the brake job. Therefore, I wanted to break them loose, then retighten them, so they would be removable when needed.

I don’t have a proper breaker bar, but do have a piece of pipe I can fit over the wrench. I reapplied the penetrating fluid, waited another fifteen minutes or so, then fit the wrench on one of the carrier bolts, then fit the piece of pipe – aka the cheater bar – over the end of the wrench.

Lying on the garage floor, I adjusted my body position, hoping to give the maximum force possible. After about five tries, I felt the wrench turn just a bit. I pushed it along as far as I could, then reset the wrench the get another 1/6th turn or so. That carrier bolt had come loose. The other one worked out virtually the same.

I was curious how much extra length the cheater bar had provided. The effective length of the wrench handle, with the cheater bar fitted onto it, was twenty inches.

It made me realize that a two-foot breaker bar or cheater bar is probably needed for general mechanic work.

Jack of Oracle Tutoring by Jack and Diane, Campbell River, BC.

Leave a Reply